|
Below are fitting instructions for the Following Fireplaces
Boxton
Click Here for Downloadable Version
| 1. Remove skirting board |
|
| 2. Ensure your floor is clean and free from loose dirt / debris |
|
| 3. Bed hearth onto floor using tile adhesive, the back edge of the hearth should be touching the wall |
|
| 4. Apply tile adhesive to the back of the back panel, the tile adhesive should be placed around the entire outside edge of the panel and the fire cut out, this should be done to ensure a good seal between the back panel and the Wall to prevent Gas fumes from leaking into the room. Apply extra blobs of tile adhesive to the rest of the back panel to ensure good adhesion.
When pushed against the wall the tile adhesive must remain 10mm thick, the back panel itself is 20mm thick, therefore the front face of the back panel should be 30mm from the wall (See fig 3)
This ensures that the fire surround when placed in situ will fit snugly against the back panel, leaving no gaps
|
  
|
| 5. Carefully position the main surround onto the hearth making sure it is central, mark the 2 fixing brackets (A & B), Drill, and fix to the wall.
|
|
| 6. Clean any excess tile adhesive with a damp cloth |
|
Your fireplace should be left for 24hrs to set before your Gas Fire is fitted
CAUTION DO NOT USE SILICON OR NO NAILS TO FIX THIS PRODUCT
DO NOT USE ANY TYPE OF DETERGENTS OR MULTI SURFACE CLEANERS TO CLEAN YOUR MARBLE FIREPLACE
TO CLEAN THE MARBLE USE A DAMP CLOTH AND A DUSTER |
|
